NAPCO iSecure Installation & Programming Instructions page 39

14. Install the ISEC-WIFI (cont'd)
Socket
Fig. 4: Antenna Wire Plug and Socket
In addition, keep the wire away from the "Top Antenna"
that runs along the top edge of the motherboard, as
shown in Fig. 2.
9. Insert the plastic Standoff into the bottom of the
ISEC-WIFI (see Fig. 5).
Fig. 5: Standoff (arrow)
10. Use Fig. 6 to locate the two Header Sockets located
near the top left side of the Hub PCB (circled). Also lo-
cate the Standoff hole (arrow).
11. With the small Antenna
Wire Plug located at the
top of the ISEC-WIFI
PC board, carefully
align the Standoff with
its hole, and align the
two Header Plugs with
their Header Sockets
(Fig. 6 & 7). Firmly
press the ISEC-WIFI
into the PC board.
12. Re-assemble the Go-
Anywhere Smart Hub
enclosure as directed in
"Install the
Anywhere Hub"
page 10.
Napco iSecure Security System
Plug
Go-
Fig. 6: "Header Sockets" (circled)
on
All technical manuals are available in PDF format at
Fig. 7: Align and insert ISEC-WIFI (PC Board)
P R O G R A M M I N G
After the ISEC-WIFI module is installed, program the Go-
Anywhere Hub using the iSecure Cloud Web Portal:
1. Log into the iSecure
www.iSecureByNapco.com
Login).
2. Enter the Radio Serial Number and click Submit.
3. Before Wi-Fi networks can be searched, click Central
Station Reporting and perform the following:
• At the top of the screen, click to select the Central Sta-
tion Reporting radio button.
• In the COMMUNICATION TECHNOLOGY pull-down,
select IP with Cell Radio Backup or IP Only, depend-
ing on your installation.
• Check Enable IP Supervision, if desired.
• In Configuration Type, select Ethernet Preferred
with WiFi Backup (non-UL).
• In IP Configuration Type, select DHCP.
• Click Save to download your changes and restart the
system.
• In Dealer Entered Programming, click Search WiFi
Networks (a popup will appear warning that scanning
may take up to 3 minutes). Click Yes to continue.
• In the Wi-Fi Networks pull-down, find and select the
SSID name of the customer's network. Upon selection,
the Security Type and Selected Network fields will
automatically populate.
• Type the Password of the customer's Wi-Fi network
and click Save. Note: The Wi-Fi Module Version will
not appear until connected.
E L E C T R I C A L R A T I N G S
Primary Operating Supply: 3.3VDC from Go-Anywhere
Smart Hub motherboard. 46mA standby current draw.
tech.napcosecurity.com
Cloud Web Portal
as a Dealer (click Dealer
at
39