Connecting The Microdock; Warning: E-Mu 0202 & Microdock - E-Mu 1212M Owner's Manual

Digital audio system
Hide thumbs Also See for 1212M:
Table of Contents

Advertisement

Secure the card into the slot using one of the screws you placed aside earlier.
5.
After all components have been installed and securely fastened, close the computer
6.
case.
Plug the power cord back into the wall outlet and turn on your computer.
7.

Connecting the MicroDock

Connect the supplied EDI cable between the 1010 PCI Card and the MicroDock.
1.
Connect the supplied +48 volt DC adapter to the +48VDC jack on the rear of the
2.
MicroDock. See the diagram below.
Connect your audio inputs and outputs to the MicroDock as shown on
3.
Turn the MicroDock on by turning the Headphone Volume control.
4.
+48V DC Adapter
48 VDC
+
-
EDI
1010 PCI Card
Warning: The MicroDock has been designed to use readily available and
inexpensive standard computer system cables. This makes it easy for you to find
replacement cables if your original cable becomes damaged or lost. However, because
these standard cables types are used for other purposes, you must use caution to avoid
connecting the cables incorrectly. DO NOT connect the supplied EDI cable to the
Ethernet or network connector on your computer. Doing so may result in permanent
damage to either your computer, the E-MU 1010 PCI card, or the MicroDock.
WARNING: E-MU 0202 & MicroDock
If you have both the E-MU 0202 I/O card and the MicroDock, DO NOT connect both
to the E-MU 1010 PCI card. They cannot be used together.
E-MU PCI Digital Audio Systems
Connecting the MicroDock
page
23.
The Headphone
Volume Control is
the Power Switch.
2 - Installation
Note: The 1616 and
m
1616
MicroDocks cannot
be used with older 1010
PCI cards identified by the
1394 FireWire port.
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1616m1616 pci1616m pci

Table of Contents