Note About Windows Logo Testing; Connecting The Microdock; Connector Types - E-Mu 1616 Owner's Manual

Note About Windows Logo Testing

When you install the Digital Audio System drivers, you will see a dialog box that
informs you that the driver has not passed Windows Logo testing.
The Digital Audio System drivers are not signed because the driver does not support
some of the consumer audio features that the Microsoft driver signing program requires,
most notably Digital Rights Management.
However, the Digital Audio System drivers have been rigorously tested using the same
test procedures that a signed driver requires, and it passes in all important categories,
including those that measure the relative stability of the driver. So, it is perfectly safe to
install these drivers on your computer.

Connecting the MicroDock

Connect the supplied EDI cable between the 02 CardBus Card and the MicroDock.
1.
Connect the supplied +48 volt DC adapter to the+48VDC jack on the rear of the
2.
Microdock. See the diagram at right.
Connect your audio inputs and outputs to the MicroDock as shown on page 18.
3.
Turn the MicroDock on by turning the Headphone Volume control.
4.

Connector Types

These connector types are used to connect the E-MU MIcroDockhardware components.
They will be referred to by the name shown in the first column of the following chart:
Name Description
EDI CAT5 Connector
S/PDIF In RCA Connector
S/PDIF Out RCA Connector
ADAT Optical In TOSLINK Optical Connector ADAT digital audio devices (or S/PDIF)
ADAT Optical Out TOSLINK Optical Connector ADAT digital audio devices (or S/PDIF)
Mic/Line Inputs XLR Jacks or 1/4" jacks
(balanced or unbalanced)
Line In/Out 1/4" connectors
Warning: The E-MU 02 CardBus card has been designed to use readily available
and inexpensive standard computer system cables. This makes it easy for you to find
replacement cables if your original cable becomes damaged or lost. However, because
these standard cables types are used for other purposes, you must use caution to avoid
connecting the cables incorrectly. DO NOT connect the supplied EDI cable to the
Ethernet or network connector on your computer. Doing so may result in permanent
damage to either your computer, the E-MU 02 CardBus card, or the MicroDock.
E-MU 1616/1616M CardBus Digital Audio System
The Headphone
Volume Control is
the Power Switch.
Connects
02 CardBus card and MicroDock
S/PDIF digital audio devices
S/PDIF digital audio devices
XLR: connect to microphone
1/4": instrument inputs or line inputs
Connect to balanced or unbalanced
inputs and outputs.
2 - Installation
Connecting the MicroDock
+48V DC Adapter
48 VDC
+ -
EDI
02 CardBus Card
11