Computer Speaker Analog Outputs; Midi 1 & 2 In/Outs; Edi Connector (Card) - E-Mu 1212M Owner's Manual

3 - PCI Card & Interfaces
The MicroDock

Computer Speaker Analog Outputs

These stereo mini-phone (3.5mm) jacks duplicate line level outputs 1-3 with a lower
output level to accommodate consumer speakers. These line level outputs are designed
to interface easily with powered speakers.
Computer Speaker Output
1 L/R
2 L/R
3 L/R
MIDI 1 & 2 In/Outs
MIDI input and output ports allow you to interface any type of MIDI equipment such
as keyboards, effect units, drum or guitar controllers (anything with MIDI). The MIDI
drivers were installed when you installed your PatchMix DSP software and the MIDI
ports will appear in your system control panel under "Sounds and Audio Devices".
There are two completely independent sets of MIDI input and output ports on the
MicroDock, which can be assigned in your specific MIDI applications.
Connect the MIDI breakout cable to the D-connector on the MicroDock. Connect
MIDI Out to the MIDI In port of your synthesizer and MIDI Out of your synth to MIDI
In of the MicroDock MIDI cable.

EDI Connector (Card)

Connects the MicroDock to the E-MU 1010 PCI card using a CAT5-type computer
cable. The cable supplied with the MicroDock is specially shielded to prevent
unwanted RF emissions.
Basic
Connections
Audio
from
Synthesizer
Out
Audio
to
Monitors
24
Duplicates Line Level Output
Tip = 1L Ring = 1R
Tip = 2L Ring = 2R
Tip = 3L Ring = 3R
MIDI Synthesizer
* *
1L 2L 2R
1R
In
1L 1R 2L 2R
Mixer
&
Speakers
MIDI In
MIDI Out
Pho no
MIDI Cable
2L 2R
Gnd
Out
1 2 3
3L 3R
Connect
Desktop
Speakers to
1/8" jacks
* Note: Line Inputs 2L/2R and Phono 2L/2R cannot be used at the same time.
Out
Turntable
MIDI 1
In
48 VDC
+ -
EDI
Powered
Desktop
Speakers
Creative Professional
AC Adapter
1010 PCI
Card