Moving The Robot; Moving The R6Yxh250, R6Yxh350, R6Yxh400 - Omron R6Y Series User Manual

2-3

Moving the robot

WARNING
SERIOUS INJURY MAY OCCUR IF THE ROBOT FALLS AND PINS
SOMEONE UNDER IT.
• DO NOT ALLOW ANY PART OF YOUR BODY TO ENTER THE AREA
BENEATH THE ROBOT DURING WORK.
• ALWAYS WEAR A HELMET, SAFETY SHOES AND GLOVES DURING
WORK.
To check the mass of each robot, refer to "1-1 Basic specifications" in Chapter 7.
2-3-1

Moving the R6YXH250, R6YXH350, R6YXH400

1) Fold the X and Y axis arms as shown in Fig. 3-4, and wind the robot cable
around the upper part of the pedestal, then fasten the robot cable with adhe-
sive tape so as not to cover the bolt installation holes.
2) Holding the support parts as shown in the figure with both hands, place the
robot on the installation base and secure it temporarily by tightening the
bolts.
(For tightening torque to secure the robot firmly, see the next section, "2-4
Installing the robot".)
Support part
3-7
CHAPTER 3 Installation
Fig. 3-4
Robot cable
Support part
Bolt installation
hole