How To Add Automatic Transmission Fluid - Buick 2009 Enclave Owner's Manual

Then, without shutting off the engine, follow these steps:
See Engine Compartment Overview on page 5-12 for
more information on location.
1. Pull out the dipstick and wipe it with a clean rag or
paper towel.
2. Push it back in all the way, wait three seconds and
then pull it back out again.
3. Check both sides of the dipstick, and read the
lower level. The fluid level must be in the
crosshatched area.
4. If the fluid level is in the acceptable range, push the
dipstick back in all the way.
The transmission fluid
dipstick handle has this
symbol on it, and is located
near the rear of the
engine compartment.
How to Add Automatic Transmission
Fluid
Refer to the Maintenance Schedule to determine what
kind of transmission fluid to use. See Recommended
Fluids and Lubricants on page 6-11.
If the fluid level is low, add only enough of the proper
fluid to bring the level into the crosshatched area on
the dipstick.
1. Pull out the dipstick.
2. Using a long-neck funnel, add enough fluid at the
dipstick hole to bring it to the proper level.
It does not take much fluid, generally less than
one pint (0.5 L). Do not overfill.
Notice: Use of the incorrect automatic transmission
fluid may damage the vehicle, and the damages
may not be covered by the vehicle's warranty.
Always use the automatic transmission fluid listed in
Recommended Fluids and Lubricants on page 6-11.
3. After adding fluid, recheck the fluid level as
described under "How to Check Automatic
Transmission Fluid," earlier in this section.
4. When the correct fluid level is obtained, push the
dipstick back in all the way.
5-23