Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer; Flash-To-Pass - Buick 2009 Enclave Owner's Manual

Turn and Lane-Change Signals

Move the lever up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until the lane change is
complete.
The lever returns to its original position whenever it is
released.
If after signaling a turn or lane change the arrow flashes
rapidly or does not come on, a signal bulb may be
burned out.
Have the bulbs replaced. If the bulb is not burned out,
check the fuse. See Taillamps, Turn Signal, Sidemarker,
Stoplamps and Back-up Lamps on page 5-50 for turn
signal bulb replacement procedures and Fuses and
Circuit Breakers on page 5-99 for location of fuses.
A chime will sound if the turn signal is left on for more
than 3/4 mile (1.2 km).
3-8
An arrow on the instrument
panel cluster flashes in the
direction of the turn or
lane change.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
This instrument panel cluster light
the high beam lamps are turned on while the ignition
is in ON/RUN.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

This feature lets you use your high-beam headlamps
momentarily to signal a driver in front of you that
you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high-beam headlamps come on, then
release the lever to turn them off.
3 comes on if