Technician Responsibilities - ActionTec V2000H Manual


Site IP Pings & Trace-route

Network Video Channel Change ZAP Time Test

Network Video Quality MDI Test; Media Loss Rate & Delay Factor
IPMax Facility Broadband & Narrowband Tests:

Emulates DSLAM Port and supports ADSL, ADSL2+, and VDSL2

Modem Synchronization, Train-up, Rate Adaption and Tone Detection

CPE Vendor Information

Customer's CPE Modem Sync (Using the Customer's Profile obtained in DSLAM Port Sync Test; Cap
Rate, INP & Delay)

OAM Test Cells To Customer's CPE Modem

DC Loop Current Measurement for ROH Detection

AC/DC Voltage R/T, T/G, R/G

Resistance R/T, T/G, R/G

Capacitance, Loop Length, Balance R/T, T/G, R/G

Load Coil Detection

3.7 Technician Responsibilities

Basic Phase (before reaching premise)

If existing customer, run InSight(Telus Metaframe application) and check Last mile and customer
profile.

Make any modifications to the line to maximize the xDSL signal.

Activate the TTV Port in FITS
Phase 1

Clear Cap the pair

Replace older, non-twisted drop

Replace the Protector with the latest standard (TII)

ALWAYS install a VDSL pots splitter

If necessary, install new Cat 5 wire from the protector to the router location.

Perform a Blast test on your circuit and log it as complete.
Figure 100: FITS Screen (Telus Metaframe)
Page 95 of 130