Drop Cables; Ont (Optical Network Terminator) - ActionTec V2000H Manual


FlexNAP is compatible with both aerial and below-grade distribution applications.
Distribution – Opti Tap on Splice Closures

Distribution cable fibers are terminated to factory installed pigtails.

Pigtails are routed to environmentally sealed OptiFit adapters

OptiFit drop cables are pre-terminated to connect to sealed adapter

No re-entry of terminal required

Integrated drop cable strain relief and grounding

Capability to integrate splitters or CWDM
Figure 108: Distribution – Traditional Cables and Splice Closures (Left) & OptiTap on Splice Closure (Right)

4.1.1 Drop Cables


Single-fiber, single-mode SC UPC drop cable assemblies

Available with one or both ends that can be connected

Cable design for aerial, direct-buried or duct installation

Standard lengths available in 15 feet increments from 90 to 180 feet and in 50 feet increments above
200 feet

Environmentally-sealed connector housing permits rapid connection to external flush-mounted
bulkhead adapters on terminals or closures (terminal or closure entry is not required for drop cable
installation).

Robust design keeps connector intact during installation

Can be pulled through 1.25-in conduit

Integral pulling eye/connector cap designed for 100 lb maximum pulling tension

4.1.2 ONT (Optical Network Terminator)


Replaces residential customers "NID" box

Converts light information to electrical information

Can operate up to 20 Km from OLT
Page 102 of 130