Inside Of Sac - ActionTec V2000H Manual

•
There are "In" ports and "Out" ports in the DSL block.
•
You must connect Dial Tone to the "In" port.
•
Then connect "Out" port to FX/customer.
•
The "In" port on the DSL takes the dial tone then injects the DSL (Frequency) on the "Out" port to
your customer.
•
If you connect the jumpers incorrectly, your DSL will not sync.
•
DSL doesn't require dial tone to work as it is transmitting a signal by itself.
•
Blue DSL Ports = Voice
•
Green DSL Ports = data
•
CO feeds(Green) goes to DSL Voice(Blue)
•
DSL data(green) goes to SAC distribution(Blue Modules)

2.3 Inside of SAC

•
To power these DSL equipment in the SAC are powered by DC voltage.
•
These Red/Black jumper are coming from the CO and they should NEVER BE TOUCHED!!
Figure 77: DSL Voice and Data
Figure 78: High Voltage Red Modules
Page 71 of 130