11 SUSPENSION SETTING
11.15
11.16
38
Handlebar position
M01659-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
M01659-11
Info
Turn clockwise to increase the damping; turn counter-
clockwise to reduce damping when the shock absorber
rebounds.
On the upper triple clamp, there are 2 holes at a distance of
each other.
15 mm (0.59 in)
A
Hole distance
The holes on the handlebar support are placed at a distance of
from the center.
3.5 mm (0.138 in)
B
Hole distance
The handlebar holder can be mounted in four different positions.
This allows the handlebar to be mounted in the most comfortable
position for the rider.
–
1
Remove screws
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
2
Remove screws
. Take off handlebar supports.
–
Place handlebar supports in required position. Mount and
2
tighten screws
.
Guideline
Screw, handle-
M10
bar support
Mount the left and right handlebar supports in the same
position.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
evenly.
A
to
B
40 Nm (29.5 lbf ft)
Loctite
®
243™
1
and tighten