Table of Contents
Advertisement
Check the fluid level, and add distilled water to the upper level when it is near the lower
1
level.
2
Check the terminals for looseness and tighten if it is too loose.
< Note >
It is necessary to recharge the battery when the
specific gravity of the battery fluid is 1.23 or less.
Request the authorized distributor where the
generator was purchased to recharge the battery.
Replacing the Battery
Remove the battery negative (-) cable. (Always
1
be sure to remove the negative (-) side first. )
2
Remove the battery hold-down clamp.
3
Remove the battery positive (+) cable.
Remove the battery.
4
* Reverse the procedure above for installing the battery.
(First, connect the positive (+) cable of the replaced battery.)
9.
Operating Procedures
9-1. Initial Startup/Pre-Check
WARNING : EXHAUST GAS POISONING
Do not operate the generator in poorly ventilated areas such as indoors or
tunnels, as the exhaust gas of the engine contains substances that are
harmful to human health.
Do not direct exhaust fumes at bystanders or buildings.
WARNING : INJURY
Always be sure to check that the breakers on load side and switches for any
equipment using the generator are at OFF before turning the breaker to ON.
Also be sure to advise personnel on the load side that power will be turned
on before operating the breaker.
Close all doors and lock them during operation.
Do not open the inspection door when the starter switch is in the AUTO or
START position. It may get caught in rotating parts such as cooling fans and
fan belt.
Always turn the starter switch to the STOP position and stop the engine, then
close and lock OPERATION PANEL DOOR before checking or maintaining
the engine or any equipment.
(+) Post
Hold-Down
Clamp
27
(-) Post
Upper Level
Lower Level
Advertisement
Table of Contents
