Starting Auto Setup - Denon AVR-1706 Operating Instructions Manual

Denon av surround receiver avr-1706 operating instructions
Hide thumbs Also See for AVR-1706:
Table of Contents

Advertisement

ENGLISH
Easy Setup and Operation

Starting Auto Setup

1
CURSOR F F
Press the
button to start the Auto
Setup.
• Start the measurements.
Measurement of each channel is performed as follows:
1
2
FL
FR
C
SW
1: Only the front speakers (A) are measured, front speakers
(B) are not available. Even if the front speakers (B) are
set, the setting automatically switches to the front
speakers (A) once measurements are completed.
2: The subwoofer speaker is measured twice.
3: When "ZONE2" is selected, this is not displayed (
page 43).
After each channel is measured, "Calculating" appears.
The display switches to the speaker check display
automatically.
2 Check the results of the speaker detection
Example: 7.1-channel systems
2
Press the
3
SL
SR
SBL
SBR
"Store", then press the
Store:
Store the checked measurement values.
All parameters are stored.
Cancel:
Cancel the checked measurement values.
3
Disconnect the setup mic to finish Auto Setup.
• Measurement is cancelled if the MASTER VOLUME control knob
is operated while the Auto Setup is performed.
• If the output volume and crossover frequency of your
subwoofer speaker can be changed, then set the volume to
halfway and the crossover filter to maximum or switch off
the low-pass filter.
• The speaker configuration, delay time and channel level
measurement values can be checked using the system
setup function (
Subwoofer
Surround and Surround back speaker
Front and Center speaker
CURSOR D D
H H
or
button to select
CURSOR F F
button.
page 38 ~ 41).
9
ENGLISH
Easy Setup and Operation
2 About automatic retry
To confirm the results of the measurements, remeasurement is
automatically performed.
Remeasurement is performed up to 2 times. During this time,
"Retry1" or "Retry2" is displayed on the display.
NOTE:
• When measurements have been made using the
measurement microphone, speakers with built-in filters,
such as a subwoofer, might be set to a value that differs
from the physical distance because of the internal electrical
delay.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents