Dell Precision 330 User Manual page 72

72 Ins ta l l i n g Up g r a d es
I n s t a l l i n g t h e D r i v e B r a c k e t ( M i n i To w e r C h a s s i s )
Connect the interface cable for the drive. See
8
(Mini Tower Chassis)."
NOTICE: To avoid possible damage, you must match the colored strip on the
interface cable with pin 1 on both the drive and system board connectors.
If you are installing an enhanced integrated drive electronics
a
(EIDE) device, ensure that the interface cable is properly
connected to the EIDE connector on the system board. For more
information, see
If you are installing a small computer system interface (SCSI)
b
device, ensure that the SCSI interface cable is properly connected
to the interface connector on the SCSI controller board. For more
information, see
Connect a DC power cable to the power input connector on the back
9
of the drive (see the following figure).
drive/bracket assembly
"EIDE Device Installation
"SCSI Device Installation
bracket tabs (2)
"Attaching Drive Cables
Guidelines."
Guidelines."