Dell Precision 330 User Manual page 67

Turn off the computer and peripherals, disconnect them from their
1
electrical outlets, wait at least 5 seconds, and then
computer cover.
Rotate the power supply
2
If necessary, remove any modules
3
sockets in which you plan to install the upgrade modules.
NOTE:
The system supports no more than a total of 64 memory devices
on all installed RIMMs. See
the RIMM that identifies the number of memory devices it contains. You
can also determine the number of memory devices installed through the
System Memory option in
Install the upgrade modules.
4
Rotate the power supply back into position, making sure that the
5
securing tab snaps into place.
Replace the computer cover, reconnect the computer and peripherals
6
to their electrical outlets, and turn them on.
NOTE:
If enabled, the
message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
The system detects that the new memory does not match the existing
system configuration information and generates the following
message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup
utility
Enter system setup, and check the value for System Memory. The
7
system should have already changed the value of System Memory to
reflect the newly installed memory. If the new total is correct, skip to
step 9.
If the memory total is incorrect, repeat
8
installed modules to ensure that they are seated properly in their
sockets. Then repeat
When the System Memory total is correct, exit system setup.
9
Run the Dell Diagnostics
10
operating properly.
away from the system board.
(RIMMs or CRIMMs) that occupy
"RIMM Label" for the location of the label on
system setup.
Chassis Intrusion
option will cause the following
step 1
step 5 through step 7.
to verify that the memory modules are
remove the
and step 2. Check the
In s ta l l i n g U p gr a d e s
67