Cleaning The Air Filter; Changing/Adjusting The Spark Plug; Sharpening The Thread Cutter - Grizzly MTS 52-15 E2 Translation Of The Original Instructions For Use

Cleaning the Air Filter

(Pic. 12)
Never operate the equipment
without the air filter otherwise
dust and dirt enter the engine
and result in damage to the ma-
chine. Keep the air filter clean.
1. Switch off the engine.
2. Press the locking device (46) at the air
filter housing (47) and remove the air
filter cover (5).
3. Remove the air filter (48) from the filter
housing (47).
4. Clean the filter with soap and water
and allow it to dry in the air.
Never use petrol!
5. Reinstall the filter in reverse order.
Replace the air filter if it is worn,
damaged or heavily soiled.
pic. 12
5 48
Changing/Adjusting
the Spark Plug
(Pic. 13)
Worn spark plugs or a spark gap
that is too great will result in a
power reduction of the engine.
1. Switch off the equipment.
2. Take the ignition cable (6) off of the
spark plug (49).
46 47
3. Screw out the spark plug (49) anti-
clockwise using the enclosed mainte-
nance key.
4. Check the spark gap with the aid of a
feeler gauge (available from specialist
retailers). The electrode gap must
be 0.6 – 0.7 mm.
5. If necessary, adjust the gap by care-
fully bending the spark plug earth
electrode.
6. Clean the spark plug with a wire brush.
7. Reinsert the cleaned and adjusted
spark plug or replace a damaged
spark plug with a new spark plug (e.g.
"Torch L8RTC or Champion RCJ6Y"
spark plug).
8. Reattach the ignition cable (6)
pic. 13
6
49

Sharpening the Thread Cutter

Wear protective gloves to avoid
cutting injuries.
1. Unscrew the thread cutter (14) from
the protective cover (15) (see pic. 1).
2. Fix the thread cutter in a vice and
sharpen the blade with a flat file. File
carefully and only ever in one direction.
Do not use the equipment without
a thread cutter or with a defective
thread cutter. If the thread cutter
blade is damaged, contact our
service centre.
GB
107