Information On The Display Panel - Siemens WN54A2A0HK Instruction Manual And Installation Instructions

:
Warning
Risk of injury!
Reaching into the drum while it is still
turning may cause hand injuries.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
Turn the programme selector to Û
1.
(Off). Pull out the mains plug.

Information on the display panel

Display
Õ
Hot
|
w lights up
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with I Start/Reload button or
select Drain p.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
The temperature in the drum is too high. Wait for the appliance running to cool
down the laundry till the Hot disappears on the display panel, then the door can be
opened.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked? ~ "Filter in the water supply is blocked" on page 46
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The childproof lock is activated – deactivate it.
Faults and what to do about them
Open the service flap.
2.
Drain the water. ~ Page 44
3.
Pull the emergency release
4.
downwards with a tool and release.
The door can then be opened.
en
47