Press the # button. Pull out the
1.
mains plug.
Open the service flap.
2.
Information on the display panel
Display
Œ
Hot
|
E:3610
H:95
H:32
w 3 sec lights up
o lights up
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with I button or select Spin pro-
gramme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked?
~ "Filter in the water supply is blocked" on page 43
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
E:36 alternating display with -10 and End when programme is finished:
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 42
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 43
H:95 alternating display with End when programme is finished: no water detected
in drying phase, may get bad drying result.
H:32 alternating display with End when programme is finished: unbalance prob-
lem, spinning phase is aborted.
The childproof lock is activated – deactivate it.
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
Faults and what to do about them
Drain the water. ~ Page 42
3.
Pull the emergency release
4.
downwards with a tool and release.
The door can then be opened.
en
45