Siemens WN54A2A0HK Instruction Manual And Installation Instructions page 52

Faults and what to do about them
en
Faults
Spin noise during the dry-
ing phase.
Fluff found on the laundry. Run the Drum Care k Ž (cold) programme without laundry and detergent to
Water inlet noise during
the drying phase.
Drying duration extended.
Drying programme does
not start.
Creasing.
52
Cause/Remedy
This is an innovative process known as thermal spinning used to reduce energy
consumption during the drying phase. It is designed like this, please wait until
programme finished.
remove fluff which have accumulated inside the drum during the previous dry-
ing cycle.
The washer dryer uses water condensation technology, water is constantly
needed to dry the laundry. Therefore the water tap must be on all the time, till
the end of the drying phase.
Run the Drum Care k Ž (cold) programme to remove fluff which has col-
■
lected in the washer drum during the drying phase.
If the ambient temperature is higher than 30 °C, this may extend the drying
■
time.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Drying additional programme setting not selected?
■
Door not closed properly?
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong program for the type of fabric. All the required information can
be found in the programme overview table.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.