Removing The Rack Front Cover; Replacing The Operating Panel Module - Fujitsu PRIMERGY TX150 S5 Service Supplement Manual

Replacement routines
4.1.2.2

Removing the rack front cover

Remove the rack front cover when making the following replacements:
– Replacing the operating panel
– Replacing the DVD/DVD-RW drive
– Replacing the intrusion switches
Ê Remove two screws on either side.
Ê Remove the rack front cover to the front.
Ê Disengage the three tabs on the top side one after the other and pull out the
plastic front cover frontward about 2 cm.
Ê Press the three hooks on the bottom side downward and pull out the plastic
front cover frontward.
4.2

Replacing the operating panel module

Ê Open the server and remove the front cover / rack front cover as described
in the section "Preparation" on page
Figure 2: Removing the operating panel module
Ê Press the two metal tongues of the EasyClick rails inward (1) until the locking
mechanism is released.
Ê Pull the operating panel module forward out of its mounting location (2) until
you can remove the ribbon cable and the USB cable from the operating
panel board. Remove the two cables.
TX150 S5
Replacing the operating panel module
17.
1
Service Supplement
1
19