Fujitsu PRIMERGY TX150 S5 Service Supplement Manual page 28

Replacing the SAS/SATA backplane
Figure 10: Disconnecting cables
2
Ê Take the I C cable out of the green cable clamp and remove the cable clamp
(1).
Ê Pull out the connectors of the power cable (2), the I
SATA cable (4) and the SMB cable (5) from the SAS/SATA backplane.
Ê Remove the four screws (two at each side) that fasten the SAS/SATA
backplane holder to the hard disk cage.
Ê Take the SAS/SATA backplane together with the holder out of the server. Be
careful with the isolation foil positioned on the rear side of the SAS/SATA
backplane.
Ê Remove the isolation foil and lift the SAS/SATA backplane from the holder.
Ê Insert the new SAS/SATA backplane in the holder.
Ê Position the isolation foil.
Ê Fasten the SAS/SATA backplane holder using the four screws on the hard
disk cage.
Ê Attach the connectors of the SMB cable, the SAS or SATA cable, the power
cable and the I
page 28).
Ê Attach the green cable clamp to the connector of the I
cable in the cable clamp.
Ê Reinstall all hot-plug hard disk drives.
28
1
2
C cable to the SAS/SATA backplane (see the
Service Supplement
2
3
4
5
2
C cable (3), the SAS or
2
Replacement routines
1
figure 10 on
C cable and place the
TX150 S5