GE EML835 Owner's Manual page 29

Be sure all surface units are turned
i
Surface unit
Drip pan
Receptacle
Porcelain Enamel Cooktop
resistant. However, any acidic foods spilled
(such as fruit juices, tomato or vinegar)
should not be permitted to remain on the
Lift-Up Cooktop
(on coil models)
Some models have a cooktop that can
be lifted up for easier cleaning. The entire
cooktop may be lifted up and supported in
the up position.
The surface units do not need to be
removed; however, you may remove one to
make raising the cooktop easier. There are
two side supports that lock into position
when the cooktop is lifted up.
Surface Units (on coil models)
Be sure all the controls are turned to OFF
and the surface units are cool before
attempting to remove them.
To clean the surface units, turn the control
to the highest setting for a minute. The coils
To remove a surface unit:
To remove the drip pans for cleaning, the
Lift the surface unit about 1 inch (2.5 cm)
above the drip pan and pull it out.
Do not lift the surface unit more than 1"
(2.5 cm). If you do, it may not lie flat on
the drip pan when you plug it back in.
Repeated lifting of the surface unit more
than 1 inch (2.5 cm) above the drip pan
can permanently damage the receptacle.
Drip Pans
(on coil models)
Remove the surface units. Then lift out the
drip pans.
Place them in a covered container. Add 1/4
cup ammonia and let soak several hours or
overnight. Wash, rinse well and dry.
The drip pans may also be cleaned in the
dishwasher.
(on radiant models)
If acids spill on the cooktop while it is hot,
use a dry paper towel or cloth to wipe it up
right away. When the surface has cooled,
wash with soap and water. Rinse well.
For other spills such as fat spatterings, wash
with soap and water or cleansing powders
after the surface has cooled. Rinse well.
Polish with a dry cloth.
After cleaning under the cooktop with hot,
mild soapy water and a clean cloth, lower
the cooktop. Be careful not to pinch your
To lower the cooktop, push the rods back
and gently lower the cooktop until it rests in
place.
NOTE : Do not lift the cooktop on radiant
top models. Lifting the cooktop can lead to
damage and improper operation of the range.
To replace a surface unit:
Replace the drip pan into the recess in the
cooktop. Make sure the opening in the pan
lines up with the receptacle.
Insert the terminals of the surface unit
through the opening in the drip pan and
into the receptacle.
Guide the surface unit into place so it rests
evenly.
Do not immerse the surface units
in liquids of any kind.
Do not clean the surface units in a
dishwasher.
Do not bend the surface unit plug terminals.
Do not attempt to clean, adjust or in any
way repair the plug-in receptacle.
Clean the area under the drip pans often.
Built-up soil, especially grease, may catch
Do not cover the drip pans with foil. Using
foil so close to the receptacle could cause
shock, fire or damage to the range.
NOTE: Do not clean the drip pans in a self-
cleaning oven.
29