GE EML835 Owner's Manual page 16

Using the clock and timer.
Make sure the clock is set to the
correct time of day.
The Timer is a minute timer only.
The Timer does not control oven
operations. The maximum setting
on the Timer is 9 hours and 59
minutes.
16
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot
be changed during a timed baking or self
cleaning cycle.
To Set the Timer
Touch the TIMER pad.
Touch the number pads until the
amount of time you want shows in the
display. For example, to set 2 hours and
45 minutes, touch 2, 4 and 5 in that
order. If you make a mistake, touch the
TIMER pad and begin again.
Touch the START pad.
After touching the START pad, SET
disappears; this tells you the time is
counting down, although the display does
not change until one minute has passed.
Seconds will not be shown in the display
until the last minute is counting down.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the TIMER pad, then touch the number
pads until the time you want appears in the
display.
To Cancel the Timer
Touch the TIMER pad twice.
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
When the Timer reaches: 00, the control
will beep 3 times followed by one beep
every 6 seconds until the TIMER pad is
touched..
The 6-second tone can be canceled by
folowing the steps in the Special features
of your oven control section under Tones at
the End of a Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the TIMER pad and then touching
the number pads to enter the new time you
want.