Troubleshooting - Life Fitness DISCOVER ST Owner's Manual

Troubleshooting

Malfunction
No Power.
Treadmill striding belt
slips off-center.
Maximum treadmill
speed is reduced.
Rubbing sound
comes from
underneath treadmill.
Display does not
illuminate when
machine is powered
on.
Probable Cause
ON / OFF switch is not in proper position.
Power source is insufficient.
Line cord is damaged.
Line cord is improperly seated in socket.
NOTE: International Platinum Club Series
Treadmills (PCST) only: You may be in
"Energy Saving Mode".
NOTE: International Platinum Club Series
Units only (PCSC, PCSR, PCSX): You may be
in "Energy Saving Mode".
Floor surface is uneven.
User is pushing striding belt. This occurs
when the runner is running faster than the
striding belt will travel, with the result of the
striding belt being pushed with the runner's
feet.
User is stalling striding belt. This will occur
with heavier users at lower striding belt
speeds. The striding belt will "stall" if the user
is traveling slower than the striding belt
speed.
Striding belt/deck malfunctions. The deck
laminate is worn through or the underside of
striding belt is glazed over (hard, glossy).
Power source is insufficient.
Foreign objects may be stuck underneath the
machine.
Loose connection at display console or motor
control board.
Corrective Action
Turn the switch to the ON position.
Plug treadmill into a dedicated 20 amp
circuit. Using a voltmeter, verify power at
outlet. If no power exists, reset circuit breaker
at panel.
Replace line cord.
Customer Support Services.
Inspect power connection at wall outlet and
at machine for proper contact.
Treadmill will go into Energy Saving Mode
after 5 minutes of inactivity. To wake the
console, step on the treadmill belt. The
treadmill will automatically wake and the
console will light up. Waking up the treadmill
takes approximately 50 seconds after
stepping onto the belt.
Unit will go into Energy Saving Mode after 5
minutes of inactivity. To wake the console,
pedal until you hear a beep. The unit will
automatically wake and the console will light
up. Waking the unit takes approximately 50
seconds after beginning to pedal.
Check levelers and level treadmill. Check
striding belt & re-tension as necessary. Refer
to Elevation Series 95T Treadmill & PCS
Treadmill Discover ST, Discover SI, & Explore
Assembly Instructions.
Instruct users not to push striding belt in
either direction.
Replace belt and deck.
Customer Support Services.
Plug treadmill into a dedicated 20 amp
circuit.
Inspect underneath striding belt and
machine. Remove any debris or objects that
may cause interference with the treadmill.
Check all electrical connections for proper
attachment. Contact
Services.
Page 76 of 82
Contact Life Fitness
Contact Life Fitness
Customer Support