Kohler VEIL K-5402A-0 Installation Instructions Manual page 6

Remove the in-wall tank from packing box. Remove paper board from cistern access opening.
Then remove the support paper board under the motor assembly.
Adjust the supporting feet height by loosening the bolts with hex key.
Slide the feet up or down to attain the ideal measurement of 308mm from the floor to the centre of the
bowl fixing holes. The frame should be installed on top of the bottom plate (usually 45mm high). Please allow
for this height when adjusting the feet.
Ensure the adjustment is even by using a level, and tighten the bolts to set the height.
IMPORTANT: Protect electronic connection point and wires from accidental damage.
Hex
key
1266554-A02-A
1 metre height label
(treat 1m as minimum).
Recommended to install frame with
1m mark at 1020mm from floor.
Bowl fixing holes
Bidet water supply
Adjustable
support feet
Hex key
6
Bottom
plate (nog)
Kohler Co. March 2016