Kohler VEIL K-5402A-0 Installation Instructions Manual page 11

3. Remove the bung from discharge port after finishing the wall preparation, then cut
off the excess of square cover and concealed conduit with a blade.
4. Insert the pan fixing bolts so the washer is hard against the finished wall, notched end outwards for tightening.
NOTE: 1. Ensure the bolt can rotate freely when preparing the wall. The washer should
be located outside the wall.
2. When preparing the wall, cross the water inlet hose, control panel signal wire
and power cord through the wall and under the tank.
Water inlet
Wall cut-out
Discharge port
Bidet water supply
F. Bowl installation
1. Remove the side panels.
2. Install the discharge pipe and water inlet pipe as shown. Place a ruler on the rear of the discharge pipe and
water inlet, and use a pencil to mark the position. Adjust the space based on the rear of the toilet to wall
discharge port.
Kohler Co. March 2016
Finished wall
(shown transparent for clarity)
Water tank
mounting bracket
Pan fixing bolt hole
Pan fixing bolt
Power supply
cord
Control panel
signal wire
Concealed conduit
11
Square cover
Blade
Fixing bolt
Bung
Bidet water
supply
Power and data cables
1266554-A02-A