Kohler VEIL K-5402A-0 Installation Instructions Manual page 10

D2. P-trap installation method
(refer to Step D1 on pg9 for S-trap installation)
1. Loosen screw on mounting bracket and
insert the waste connector.
Adjust waste connector position and
tighten the mounting bracket to secure.
E. Prepare and finish the wall
IMPORTANT: 1. When preparing the wall, the wallboard/tiling cut-out must fit very neatly around the
square cover of flush panel. No large gaps are permitted (tolerance of approx 1mm).
2. There may be significant amounts of dust when preparing the wall - be sure to fit dust cover
over cistern opening and protect the electrical fittings and pipework.
Cover the
water inlet
Pan waste connector
Bung
1266554-A02-A
Mounting bracket
securing screw
Bowl fixing hole
10
Waste connector
for DN80 pipe
Finished wall
Square cover
Kohler Co. March 2016