D-Link DWL-7200AP Manual page 17

Using the Configuration Menu (continued)
Advanced > Mode (continued)
PtMP Bridge -
wireless LANs must be using DWL-7200APs. Click to enable, and enter up to 8 remote
AP MAC addresses.
Site Survey
Click
AP Repeater -
will allow you to repeat the wireless signal of the root AP. Click to enable
and enter the MAC address of the root AP.
AP Client -
will transform any IEEE802.3 Ethernet device (e.g., a computer, printer,
etc.) into an 802.11a or 802.11g wireless client when it communicates with another
DWL-7200AP that is acting as an AP. Click to enable and enter the MAC address of
the DWL-7200AP that is acting as the AP.
Apply -
Click Apply if you have made any changes.
Find the MAC address of the DWL-7200AP that is acting as a Remote Access
Point or a Remote Bridge, by going to Status > Device Info in the configuration
utility of the remote DWL-7200AP. There you will find the MAC address.
MAC Address - Media Access Control Address
A unique hardware address that identifies a device on a network. It is assigned
at the factory and cannot be changed. Usually you will find this address on a
sticker on the device or on the packaging.
will allow you to connect multiple wireless LANs together. Other
to see the configuration of the devices on the network.
17