Table of Contents
Advertisement
Error messages
Problem
CANNOT CONNECT TO
CAMERA
Protected pic.
Remove protection.
Cause & Solution
The following may be causing the problem.
R The Wireless Camera is turned off.
– Turn the Wireless Camera on.
R The batteries of the Wireless Camera have run out of
power.
– Replace the batteries.
R The Wireless Camera is turned on, but the Wireless
Camera is out of range from the Base Unit.
– Move the Base Unit to an area close to the Wireless
Camera that has no obstructions between the Wireless
Camera and Base Unit. (When the Wireless Camera is
in range of the Base Unit it can connect to the Base Unit.)
– Turn the power for the Wireless Camera off then on.
(When the Wireless Camera is in range of the Base Unit
it can connect to the Base Unit.)
– When using a replacement Wireless Camera when
servicing your original Wireless Camera, the
replacement Wireless Camera must be paired to the
Base Unit. Refer to the following for instructions on how
to pair the Wireless Camera.
n How to pair Wireless Cameras
After performing operations on the Base Unit, perform
operations on the Wireless Camera within about 2 minutes.
Base Unit operations:
A Press and hold the pair button located on the rear bottom
side of the Base Unit for about 13 seconds (until the pair
indicator flashes quickly) with a pointed object.
R The pair indicator will start to slowly flash after about 3
seconds of pressing the pair button, after about an
additional 10 seconds the pair indicator starts flashing
quickly (enters CAMERA PAIRING MODE).
Wireless Camera operations:
B Insert the batteries (page 19).
C Turn the power for the Wireless Camera on while pressing
the pair button with a pointed object (keep pressing the pair
button until the pair indicator starts flashing).
R The pair indicator starts flashing quickly.
– The pair indicator changes in the following manner
when pairing is successfully completed:
flash quickly ® light for about 10 seconds ® go out
– The pair indicator changes in the following manner
when pairing fails (Pairing must be performed
again.):
flash quickly ® go out
R The images are protected and therefore cannot be deleted.
– Remove the protection to delete protected images.
Help
Page
11
30
8
11
25
35
Advertisement
Table of Contents
