Table of Contents
Advertisement
Programming function settings
You can change the function settings to suit your needs.
How to change the function settings
1
Press MMENUN, then select the "ALL SETTINGS" by pressing MDN, MCN, MFN, or MEN.
2
Press M
N (monitor button) ("OK"), then select the desired item by pressing MDN or MCN.
3
Press M
N (monitor button) ("OK").
4
Press MDN or MCN to select the desired setting, then press M
R This step may vary depending on the feature being programmed.
5
Press MDN or MCN to select the desired setting, then press M
6
To finish the operation, press MMENUN 2 times.
Note:
R When no operation is performed for about 60 seconds during settings, the setting function quits.
Function list
In the following list, < > indicates the default settings.
Item
START-UP
SETTINGS
DISPLAY/SOUND
SETTINGS
SAVE CAMERA
*1
BATTERIES
Function
MOTTLED COLOR
*1
PREVENT
TIME AND DATE
*1
SETTINGS
LANGUAGE
SELECTION
WIDE/ZOOM
*1
SETTINGS
CONTRAST
OPERATION
GUIDANCE
CONFIRMATION
SOUND
–
N (monitor button) ("OK").
N (monitor button) ("OK").
Setting
<POWER FREQUENCY (60Hz)> / POWER FREQUENCY
(50Hz)
R To prevent mottled or uneven color from being
displayed, set the power frequency to match the area in
which you use the unit.
You can set the current date and time (page 16).
<ENGLISH> / FRENCH / SPANISH / ARABIC
<WIDE> / ZOOM
R Select how images are initially displayed: Wide or Zoom.
When it is difficult to see the monitor display, you can
adjust the display contrast. 5 levels are available.
<YES> / NO
R Select NO if you do not want the operation guidance
(page 13, 25) to be displayed when viewing Wireless
Camera images or recorded images.
<ON> / OFF
R When OFF is selected, all sounds (apart from audio
from talking) are turned off.
<OFF> / ON
R Select ON to lengthen the time that the batteries can be
used for. (However, by selecting ON, the time it takes to
display images when monitoring may increase.)
How to use
27
Advertisement
Table of Contents
