Panasonic VL-SDM200A Operating Instructions Manual page 33

Base Unit/Wireless Monitor
Problem
Even when the Wireless
Monitor is placed on the
Base Unit (or the charger
of additional Wireless
Monitors), the charge
indicator does not light up.
Even if the Wireless
Monitor has been
charged, flashes
after using it a few times.
The Wireless Monitor or
the Base Unit (or the
charger of additional
Wireless Monitors) is
warm.
Others
Problem
The Wireless Camera's
batteries run out of power
quickly.
There is a power failure.
Cause & Solution
R The power plug is unplugged from the power outlet.
– Plug the power plug into the power outlet firmly.
R The Wireless Monitor is not placed on the Base Unit
correctly.
– Replace it securely. (The charge indicator lights in red.)
R The charge contacts are dirty.
– Wipe them with a soft dry cloth.
If there is no change after performing the above actions,
contact our service personnel.
R The battery pack is at the end of its life.
– Replace the battery pack with a new one.
R This is normal. (It may feel a little warmer in summer than
in winter.)
– If it feels very hot, unplug the power plug from the power
outlet and remove the battery pack, then contact our
service personnel.
Cause & Solution
R The Wireless Camera is out of range of the Base Unit.
– When the Wireless Camera is out of range of the Base
Unit, it repeatedly searches for the Base Unit which
causes the batteries' power to be consumed faster.
Move the Base Unit so that it is within range of the
Wireless Camera.
R The power plug is unplugged from the power outlet.
– When the Base Unit is disconnected from the power
outlet it causes the Wireless Camera to become out of
range from the Base Unit. This causes the Wireless
Camera to repeatedly search for the Base Unit which
results in the batteries' power being consumed faster.
When unplugging the power plug of the Base Unit, turn
the slide switch of the Wireless Camera to OFF.
R You are using rechargeable batteries.
– Depending on the capacity of the rechargeable batteries,
their life span may become shorter. This is not a
malfunction.
R The unit does not work during a power failure. The date
and time may be reset to the default setting after a power
failure.
– In this case, set the date and time again using the
Wireless Monitor.
Help
Page
15
15
31
–
30
–
Page
14
–
–
16
33