Table of Contents
Advertisement
Help
Troubleshooting
Display issues
Problem
Images appear slightly
distorted.
The image of a person's
face is dark.
The image is not clear or
is blurry.
The image of the subject
is washed out when it is
dark.
The image is white or
black.
The image is white, or
white lines or circles are
shown on the display.
The image is flickering.
The image displayed on
the Wireless Monitor
distorts or is displayed
slowly. (It takes about 5
seconds or more to be
displayed.)
The recording date and
time are not displayed
while viewing images.
32
Cause & Solution
R This is a characteristic of camera lenses and is not a
malfunction.
R When there is a backlight in the place where the Wireless
Camera is located, the person's face becomes dark.
– Adjust the brightness of the display while monitoring.
R The surface of the lens of the Wireless Camera is dirty.
– Clean it with a soft dry cloth.
R The surface of the lens of the Wireless Camera is wet with
dew. Wait for the condensation to evaporate.
R When it is dark, the image brightness is automatically
adjusted in order to make the person's face easier to see.
Although images may appear washed out, this is not a
malfunction.
R The brightness of the display is not properly adjusted.
Adjust the brightness while monitoring.
R Strong light such as sunlight is shining into the lens of the
Wireless Camera. Though this may cause the display
image to become difficult to see, this is not a malfunction.
– Locate the Wireless Camera away from direct sunlight.
R The MOTTLED COLOR PREVENT setting does not match
the power frequency for the region that you are using the
unit in.
– Matching the power frequency for the region that you are
using the unit in can improve the quality of the colors
displayed. When using the unit in a different region (after
moving, etc.), match the settings to that region.
R AC (alternating current) lights such as fluorescent lights
may cause flickering. This is not a malfunction.
R The distance between the Base Unit and Wireless
Camera, or Base Unit and Wireless Monitor is too far, or
there is a concrete wall or other obstruction between the
Base Unit and Wireless Camera, or Base Unit and
Wireless Monitor.
– Move the Base Unit to a location closer to the Wireless
Camera that has no obstructions, or move the Wireless
Monitor to a location closer to the Base Unit that has no
obstructions.
R The date and time are not set. The date and time may be
reset to the default setting after a long periods with the
power plug unplugged or when a power failure occurs.
– Set the current date and time using the Wireless Monitor.
Page
–
23
30
–
–
23
–
27
–
8
16
Advertisement
Table of Contents
