Supermicro X11DPX-T User Manual page 98

Super X11DPX-T User's Manual
*If the feature, Configure sSATA as, is set to AHCI, the following features will become
available for user's configuration:
sSATA Port 0~ Port 5
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Hot Plug (sSATA Port 0~ Port 5)
Select Enabled to enable a SATA port specified by the user. The options are Disable and
Enable.
Spin Up Device (sSATA Port 0~ Port 5)
On an edge detect from 0 to 1, set this feature to allow the PCH to initialize the device.
The options are Disable and Enable.
sSATA Device Type (sSATA Port 0~ Port 5)
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
*If the feature, Configure SATA as, is set to RAID, the following features will become
available for user's configuration:
sSATA RSTe Boot Info
Select Enable to provide the full int13h support for SATA controller attached devices. The
options are Disable and Enable.
sSATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
sSATA Port 0~ Port 5
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Hot Plug (sSATA Port 0~ Port 5)
Select Enabled to enable a SATA port specified by the user. The options are Disable and
Enable.
98