Table of Contents
Advertisement
Super X11DPX-T User's Manual
SATA HDD Unlock
Select Enable to unlock the HDD password. The options are Disable and Enable.
Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link to a low power state when the I/O is inactive for
an extended period of time, and the power state will return to normal when the I/O becomes
active. The options are Disable and Enable.
*If the feature, Configure SATA as, is set to AHCI, the following features will become
available for user's configuration:
SATA Port 0~ Port 7
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Hot Plug (SATA Port 0~ Port 7)
Select Enabled to enable a SATA port specified by the user. The options are Disable and
Enable.
Spin Up Device (SATA Port 0~ Port 7)
On an edge detect from 0 to 1, set this feature to allow the PCH to initialize the device.
The options are Disable and Enable.
SATA Device Type (SATA Port 0~ Port 7)
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
*If the feature, Configure SATA as, is set to RAID, the following features will become
available for user's configuration:
SATA RSTe Boot Info
Select Enable to provide the full int13h support for SATA controller attached devices. The
options are Disable and Enable.
Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link to a low power state when the I/O is inactive for
an extended period of time, and the power state will return to normal when the I/O becomes
active. The options are Disable and Enable.
96
Advertisement
Table of Contents
