Enabling Fips 140 Mode And Checking For Compliance - Xerox WorkCentre 7970 System Administrator Manual

Security

Enabling FIPS 140 Mode and Checking for Compliance

In CentreWare Internet Services, click Properties>Security>Encryption.
1.
Click FIPS 140-2.
2.
3. Click Enable.
Click Run Configuration Check and Apply.
4.
A pass or fail message appears:
If the configuration check passes, click Reboot Machine to save and restart the printer.
−
− If the configuration check fails, the reasons for the failed test list in a table at the bottom of
the page. For each reason, a link is provided. Click the appropriate link to disable the protocol,
replace the certificate, or allow the printer to use the non-compliant protocol.
Note: When FIPS 140 Mode is enabled, only FIPS-compliant certificates can be installed on the
printer.
®
90 Xerox WorkCentre
System Administrator Guide
®
7970 Multifunction Printer