Setup Menu - Crestron Isys TPS-6000 Operation Manual

15 Inch Tilt Touchpanel

SETUP MENU

INTERFACE MENU
12 • 15 Inch Tilt Touchpanel: Crestron Isys™ TPS-6000
Setup Menu
To access the SETUP MENU, shown to the left, press the Setup button from the
MAIN MENU. The SETUP MENU offers a series of buttons, which opens
additional menus and displays, which are detailed in subsequent paragraphs. Many
touchpanel options (i.e., standby timeout and brightness) are available directly from
the SETUP MENU and are explained in the following paragraphs. Other setup
parameters (i.e., interface, RS-232, audio, RGB, and video) use additional menus
and are detailed in subsequent paragraphs as well. After setup parameters have been
set, select the Return button to return to the MAIN MENU.
NOTE: The current CRESNET ID setting is displayed in the upper left corner of
the SETUP MENU.
NOTE: All touchpanel settings are automatically saved in non-volatile memory.
NOTE: The Ethernet, RGB, and Video buttons will only be displayed if the
respective TPS-ENET, TPS-XVGA or TPS-VID-1/2 cards are installed.
NOTE: If the TPS-VID-2 is installed, two video buttons will be displayed: "Video
1" and "Video 2". Press the button for the respective video source.
The touchpanel display can be turned off (standby mode) when not in active use.
STANDBY TIMEOUT, located on the left side of the SETUP MENU, can turn off
the touchpanel display when the screen has not been touched for a specified time
frame (minutes, shown as 90 in the illustration). When the touchpanel is activated,
the last screen to be displayed reappears. Minutes can vary from 0 to 120, where 0
disables the timeout. DOWN and UP buttons decrease and increase the timeout,
respectively.
Screen brightness may need to be altered because of ambient light conditions or
personal preference. BRIGHTNESS, located in the lower left corner of the SETUP
MENU, can change the brightness level of the display. The current brightness setting
is shown as a percentage in the SETUP MENU (e.g., 93% brightness is shown in the
illustration). Percentage can vary from 0% (low brightness) to 100% (full
brightness). DOWN and UP buttons decrease and increase the brightness,
respectively.
Interface Menu
The touchpanel communicates with a control system to activate commands or to
display feedback from components within the system. The communication interface
must be correctly specified or communication will not occur. To set communication
parameters select the Interface button located on the SETUP MENU and display the
INTERFACE MENU, shown to the left.
The Cresnet network identity number (CRESNET ID) is displayed on the
INTERFACE MENU. CRESNET ID is the two-digit hexadecimal number. The
hexadecimal number can range from 03 to FE and must correspond to the Net ID set
in the SIMPL Windows program of the Cresnet system. Matching IDs between
touchpanel and SIMPL Windows program is required if data is to be successfully
transferred. The Net ID for the TPS-6000 is factory set to 03, and no two devices in
the same system can have the same Net ID.
Crestron Isys™ TPS-6000
Operations Guide - DOC. 5864A