Removing And Installing The Grille - Sanyo SAP-K77GHAX Technical & Service Manual

7-5. Removing and Installing the Grille

Basically, these models can be installed and wired without removing the grille. If access to any internal part is need-
ed, follow the steps as given below.
How to remove the grille
(1) Open the front panel until it is nearly horizontal, grasp the sections near the front panel arms on both sides, and
then remove the panel by pushing the arms towards the outside while pulling the panel towards you. (Fig. 9)
(2) Lift the anti-mold filter up slightly to disengage the protrusions from the hooks on the unit, and then pull
downward to remove the filter from the unit. (Fig. 9)
(3) Remove the 4 screws. Grasp the grille on both bottom sides, and pull it towards you slightly. (Fig. 10)
(4) Press the 2 tabs on the top of the grille to disengage them. (Fig. 10)
(5) Pull the grille towards you to remove it. (Fig. 10)
Front panel
Anti-mold filter
How to replace the grille
(1) Insert the bottom of the grille into the frame.
(2) While aligning both edges of the grille with the frame, move the grille
horizontally and insert the top and bottom into the frame.
(3) Press the grille firmly with your hand to ensure no gap exists between
the frame and grille.
(4) Tighten the 4 screws.
(5) Grasp the sections near the front panel arms on both sides, and hold the
front panel so that it is nearly horizontal. Push the arm shafts towards the
outside so that they come into contact with the top of the indentations on
the right and left sides of the air conditioner. Then push firmly until the
arm shafts click into place. (Fig. 11)
(6) Insert the top of the anti-mold filter, and then fit the protrusions on the
bottom of the filter all the way into the hooks on the unit.
(7) After closing the front panel, press firmly on the parts indicated by the
arrows to securely fasten the panel in place. (Fig. 12)
NOTE
Check that no gap exists between the frame and the grille.
Arm
Protrusions
Fig. 9
Grille
Screw
43
Fig. 10
Front panel
Fig. 11
Fig. 12
Indentation
Arm
Pin