Operation Without The Remote Control Unit; Care And Cleaning - Sanyo SAP-K77GHAX Technical & Service Manual

NOTE
• The flap automatically closes when the unit is off.
• During the heating operation, the fan speed will be
very low and the flap will be in the horizontal position
(position ) until the air being blown out of the unit
begins to warm. Once the air warms up, the flap
position and fan speed change to the settings
specified with the remote control.
CAUTION
• Use the FLAP button on the remote control to
adjust the position of the flap. If you move the flap
by hand, the flap position according to the remote
control and the actual flap position may no longer
match. If this should happen, shut off the unit,
wait for the flap to close, and then turn on the unit
again; the flap position will now be normal
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around
the air vent and drip down.
Operation without the
Remote Control Unit
INDOOR UNIT
If you have lost the remote control unit or it has trouble,
follow the steps below.
When the air conditioner is not running
Each time the ON/OFF button is pressed,
the operation mode changes cyclically.
COOLING OPERATION
on
lamp
beeping
once
sound
The type of operation is indicated by the OPERATION
lamp lighting and the beeping sound.
14
OPERATION
TIMER
OPERATION
button
ON/OFF
(ON/OFF)
HEATING OPERATION STOP
on off
twice once

Care and Cleaning

1. For safety, be sure to turn the air conditioner
off and also to disconnect the power before
cleaning.
2. Do not pour water on the indoor unit to clean it.
This will damage the internal components and
cause an electric shock hazard.
Casing and Grille (Indoor Unit)
Clean the casing and grille of the indoor unit with a
vacuum cleaner brush, or wipe them with a clean,
soft cloth.
If these parts are stained, use a clean cloth moistened
with a mild liquid detergent. When cleaning the grille,
be careful not to force the vanes out of place.
CAUTION
1. Never use solvents, or harsh chemicals when
cleaning the indoor unit. Do not wipe the
plastic casing using very hot water.
2. Some metal edges and the fins are sharp and
may cause injury if handled improperly; be
especially careful when you clean these parts.
3. The internal coil and other components of
the outdoor unit must be cleaned every year.
Consult your dealer or service center.
Anti-Mold Filter
The anti-mold filter behind the Front Panel should be
checked and cleaned at least once every two weeks.
How to remove the anti-mold filter
Grasp both ends of the front panel
and pull forward and up to
open the front panel.
Lift the anti-mold filter up
slightly to disengage
the protrusions from
the hooks on the unit,
and then pull downward
to remove the filter
from the unit.
Front Panel
Claw
Anti-mold filter