Table of Contents
Advertisement
setup screen
Upgrade / Reboot
1.
From the Setup menu, select the
<System (
2.
Click <Upgrade / Reboot>.
3.
Select a desired item and set it
appropriately.
Upgrade : Performs upgrading the
system.
Factory default : Resets the system
to the factory default.
-
Except network parameter :
Reset the other settings except for the interface/port/DDNS/IP fi ltering settings.
-
All : Resets all settings including the network encoder settings. (however, the
log information will not be reset)
If you reset the network encoder, the network settings will be adjusted so that DHCP can be enabled.
If there is no DHCP server in the network, you must run the IP Installer program to change the basic
network settings such as IP address, Subnet mask, Gateway, etc., before you can connect to the
network.
Confi guration backup & Restore : Backs up the current system settings before
performing the restoration process. The system is automatically restarts after
backup or restoration.
Restart : Restarts the system.
4.
When done, click [Restart (
60_ setup screen
)> tab.
)].
Advertisement
Table of Contents
