Samsung SPE-400 User Manual page 29

6. Click [OK].
Manual network setup will be completed.
7. When the manual setup including IP is completed, the network encoder will restart.
If the Broadband Router has more than one network encoder connected
Configure the IP related settings and the Port related settings distinctly with each other.
Category
IP Address
IP related
Subnet Mask
settings
Gateway
Port related HTTP Port
settings VNP Port

M
If the <HTTP Port> is set other than 80, you must provide the <Port> number in the address
bar of the Internet browser before you can access the network encoder.
ex) http://IP address : HTTP Port
http://192.168.1.100:8080
Auto Network Setup
Run <IP Installer_vX.XX.exe> to display the network encoder search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.

M
For network encoders found with the IPv6 setting, these buttons will be grayed out as the network
encoders do not support this function.
1. Select a network encoder in the search
list.
Find the MAC (Ethernet) address labeled
on the rear of the network encoder.
Both the [Auto Set] and [Manual Set]
buttons will be activated.
2. Click [Auto Set].
The Auto Setting dialog appears.
The <IP Address>, <Subnet Mask>, and <Gateway> will be set automatically.
CH 1 CH 2
192.168.1.100 192.168.1.101
255.255.255.0 255.255.255.0
192.168.1.1 192.168.1.1
8080 8081
4520 4521
CH 3 CH 4
192.168.1.102 192.168.1.103
255.255.255.0 255.255.255.0
192.168.1.1 192.168.1.1
8082 8083
4522 4523
English _29