Control Panel Setup; Lan Menu; Tcp/Ip - Oce cx2100 User Manual

6

Control panel setup

LAN menu

Before using your Océ product in a network environment, you need to configure the correct TCP/IP settings.
In this chapter, you will learn how to configure the network settings using the control panel, located on the
front of the machine.
The LAN menu selections of the control panel allow you to set up the cx2100 for your network configuration.
Press Menu, then press a or b to choose LAN. Proceed to the menu selection you wish to configure. See
Function table and default factory settings on page 181.
Please note that the machine is supplied with the BRAdmin Light utility and Remote Setup applications for
®
Windows and Macintosh
the print server settings on page 16 for a wired connection or Changing the print server settings on page 29
for a wireless connection.

TCP/IP

If you connect the machine with the Ethernet cable to your network, use the Wired menu selections. If you
connect the machine to a wireless Ethernet network, use the WLAN menu selections.
This menu has ten sections: BOOT Method, IP Address, Subnet Mask, Gateway, Node Name,
WINS Config, WINS Server, DNS Server, APIPA and IPv6.
BOOT Method
This selection controls how the machine obtains an IP address. The default setting is Auto.
Note
• If you do not want your print server configured via DHCP, BOOTP or RARP, you must set the BOOT
Method to Static so that the print server has a static IP address. This will prevent the print server from
trying to obtain an IP address from any of these systems. To change the BOOT Method, use the machine's
control panel, BRAdmin Professional utility, Remote Setup or Web Based Management (web browser).
• You cannot change the BOOT method using the BRAdmin Light utility that was supplied on the CD-ROM
with your Océ product. Please use the latest BRAdmin Professional utility that is available as a download
from http://www.oceusa.com. This utility is only available for Windows
a
Press Menu.
b
Press a or b to choose LAN.
Press OK.
c
(For Wired) Press a or b to choose Wired.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d
Press a or b to choose TCP/IP.
Press OK.
®
, which also can be used to configure many aspects of the network. See Changing
®
users.
6
6
6
6
6
76