Build System - Crestron D3 PRO Reference Manual

Software
92 • Crestron D3 Pro™

Build System

The Finish View system tree shows all Cresnet, Ethernet and wireless devices
arranged by type (or by room, if you have selected the Sort by Room option). The
system tree lists the name of each device, its type, and its Network ID. Once you
have connected the control system, touchpanels and lighting modules to the network
and you have established communication to the PC, click the Verify Hardware
button at the bottom of the screen. This will cause the D3 Pro lighting software to
poll the network and compare the devices in your lighting program with those it
actually detects on the network.
As shown below, if a device has not yet been detected on the network, it will be
crossed out by a red X. Wireless devices with no physical connection to the network
will be marked by a yellow question mark, indicating that their presence cannot be
confirmed. In addition, the control processor will be preceded by a *!*, if the logic
program has not yet been compiled or if the system has been changed in any way
since the program was built last.
Click the Build System
system logic program. Before the build occurs the D3 Pro synchronization utility will
attempt to communicate with the processor in case any learned-lighting presets need
to be synchronized. Once the build begins D3 Pro will first generate any touchpanel
projects that have not already been compiled. The Touchpanel Build Status pane
will display information about the project, as in Programming View. However, D3
Pro will not automatically open the VisionTools Pro-e project.
After all the touchpanel projects are created, D3 Pro will generate the control system
logic program. A progress bar will display information about the program as it is
created and compiled.
button to generate the touchpanel projects and control
Crestron D3 Pro
Reference Guide – DOC. 5998a
™