Table of Contents
Advertisement
Crestron Serial Mouse Control Driver
Hardware Tab
NOTE: COM port selection is the only item that can be changed. Adjusting any other setting
will cause the driver to fail, requiring the driver to be reinstalled.
NOTE: For additional keyboard functionality programmed into the touchpanel, refer to
"Appendix 1 - Keyboard
Configuring the System
The PC that contains the Serial Mouse Control Driver may be configured for serial, Cresnet,
or Ethernet communication with the touchpanel. TPS tilt touchpanels may contain a
TPS-XVGA or TPS-XVGA-BV card. TPS lectern touchpanels (and TPS-TPI user interface)
utilize a TPS-XVGAL card. To configure the PC, touchpanel, and specific TPS-XVGA card,
refer to an appropriate section below and or on the next eight pages.
PC to Touchpanel Serial Communication
For Serial Mouse Control Driver operation using serial communication from the PC to the
touchpanel, refer to the steps below.
Serial Communication #1 - Tilt Touchpanel with TPS-XVGA
VGA
PORT
PC
Programmer's Guide - DOC. 5916A
Functionality" on page 23.
1. At the touchpanel, enter the setup mode. From the Main menu screen, press
Setup, then RS-232. Press RS-232 Port for Touch Output.
2. Refer to the appropriate (for TPS-XVGA, TPS-XVGA-BV, or TPS-XVGAL
card) diagrams and tables below and on the next page and make the cable
connections.
A
RGB CABLE
COMMUNICATIONS CABLE
B
COM
PORT
NET (OR
CRESNET)
PORT
PROFESSIONAL CONTROL PROCESSOR
CRESTRON
CONTROL SYSTEM
TPS-IMC
(OR TPS-IMW)
C
CRESNET
WIRING
NET
NET/
PORT
VIDEO
PORT
MENU
BKLT
PRO
2
Software
TILT TOUCHPANEL
WITH TPS-XVGA
TO
RGB
RS-232
PORT
PORT
NET/
VIDEO
D
PORT
Serial Mouse Control Driver • 5
Advertisement
Table of Contents
