Sync Learned Lighting; Set Network Ids - Crestron D3 PRO Reference Manual

Software
86 • Crestron D3 Pro™

Sync Learned Lighting

If you had previously uploaded a project that included buttons enabled for learnable
lighting, the end user may have made changes to certain light levels without your
knowledge. If you were to modify the project and rebuild and upload, you would
overwrite those changed presets with the original levels stored in the program.
To prevent this scenario D3 Pro provides a "Synchronize Learned Lighting Presets"
utility, which allows D3 Pro to retrieve the new preset information from the control
processor and update the D3 Pro project accordingly. D3 Pro performs this check
automatically before building a system. To explicitly activate the utility click the
Sync Learned Lighting
The synchronization utility confirms that the D3 Pro system is the same as the one
loaded into the control processor. If the system names do not match, then no
synchronization will occur.
If a learnable preset has been modified in D3 Pro to the extent that a circuit has been
added or removed, performing the Sync Learned Lighting operation will only
synchronize those lights which are common to the preset at the time of the last
upload.

Set Network IDs

Cresnet IDs are two-digit hexadecimal values that must be unique in order to identify
each device on the Cresnet network. All Crestron devices that communicate over
Cresnet, including CLX control modules, have an internal Cresnet ID that is set at the
factory. This internal Cresnet ID has to match the Cresnet ID that is assigned in the
D3 Pro lighting program. For example, if you have a CNX-B6 keypad in your
lighting system, the internal Cresnet ID of that keypad has to match the Cresnet ID
that is shown in D3 Pro.
In some cases you will need to change the internal Cresnet ID to match the Cresnet
ID assigned by D3 Pro.
The procedure for setting Cresnet IDs differs depending on the device and perhaps
the firmware version of the device. With some firmware versions, only the device
currently being configured can be connected to the network, while all other devices
have to be disconnected from the network. Crestron's newest firmware upgrades
allow automatic configuration of Cresnet IDs, with no need to take devices offline.
Devices that can be configured in this way are referred to as touch-settable devices.
In fact, most Cresnet devices are touch-settable, including Crestron CLX modules
and C2N/CNX/CLW keypads.
D3 Pro provides options for configuring Cresnet IDs in both touch-settable and non
touch-settable devices.
To Set Network IDs
Connect all touch-settable and non touch-settable devices to the network and click
the Set Network IDs button at the bottom of the screen. This will start the Network
ID Wizard, which gives you three options:
You can "Change the current system", which allows you to keep the current
configuration and set or change Cresnet IDs for new or existing devices; or
toolbar button.
Crestron D3 Pro
Reference Guide – DOC. 5998a
™