Vacation Scheduler - Crestron D3 PRO Reference Manual

™
Crestron D3 Pro
Reference Guide – DOC. 5998a
Editing Scheduled Events
D3 Pro provides Scheduler templates that allow the end user to edit the properties of
a scheduled event via a touchpanel. Using these touchpanel pages, end users can
press buttons to scroll through the list of scheduled events, suspend individual events,
or change the time events occur. (However, they cannot add or delete scheduled
events or modify what the events do.) When they are finished, they have the option to
cancel or save their edits, or to permanently save the edits.
If you schedule events, VisionTools Pro-e automatically programs the Scheduler
pages and buttons when you "Launch VT Pro-e". The Scheduler also provides two
commands that you can assign to any button: Enable and Disable. These commands
simply turn the Scheduler on and off.

Vacation Scheduler

The Vacation Scheduler is a built-in utility that memorizes and replays light levels
over a one or two week period. This is useful, as the name implies, for maintaining a
semblance of occupancy while residents are on vacation.
Before building a system that includes Vacation Scheduler programming, you must
specify the location where the run-time data will be stored. In System Properties (on
the Edit menu), select either Compact Flash or NVRAM from the RunTime Data
Storage section of the General tab. If you select Compact Flash, be sure that you have
a formatted Compact Flash card installed in the control processor. To set scheduling
options, click go to the Vacation Scheduler tab.
As shown above, the available scheduling options are:
Software
Crestron D3 Pro™• 81