Device Commands - Crestron D3 PRO Reference Manual

™
Crestron D3 Pro
Reference Guide – DOC. 5998a
8. To edit an existing command, simply double-click the command to bring up
the Edit Step dialog box. Edit the command as desired and then click Apply
or OK to accept the changes. (Both buttons will apply the changes to the
event tab, but the OK button will close the dialog box.)
9. Once you have defined commands, you can change the position of
programming steps simply by clicking and dragging. This makes it easy to
place the steps in a particular order for clarity, and to move steps into and out
of conditional statements.

Device Commands

As just described, you assign an action to a button by selecting the target device you
want the button to control, and then selecting an action from the Command list. The
available actions differ depending on the type of device:
D
IMMABLE LIGHTS AND NON
Dimmable and non-dimmable lights have three commands: Raise, Lower, or Level.
For dimmable lights, Raise and Lower are digital commands that smoothly raise or
lower the current light level until the user lets go of the button, or until the level
reaches 100% (or 0%). The default ramping speed is set in the System Properties
Lighting tab.
For non-dimmed lights the Raise and Lower commands simply turn the light on and
off.
If the Raise or Lower command must be maintained for a set period of time, you can
click the Activate this command for X seconds button and enter the required
activation time. Otherwise it will activate while the button is being pressed.
For dimmable lights, Level is an analog command that sets the lighting level to a
specified value within a specified fade time. The Level command is the default
command for dimmable lights. Thus when you select a light from the Target list, the
Level command is selected automatically. For non-dimmed lights, values for the
Level command can only be On (100%) or Off (0%).
If you select the Level command for dimmable lights, you have to enter the Target
Value and Fade Time. In the following example, 100% is the target value and 5s is
the fade time, meaning that this command will adjust the lighting level from its
current value to 100% in 5 seconds.
-
DIMMED LIGHTS
Software
Crestron D3 Pro™• 61