Load Schedule View - Crestron D3 PRO Reference Manual

™
Crestron D3 Pro
Reference Guide – DOC. 5998a

Load Schedule View

The Load Schedule View allows you to add loads, also called controlled circuits, to
your D3 Pro system. Loads are connected to Crestron's CLX and CLW control
modules, which support all standard fixtures and load types, as shown in the
following table:
Control Module
CLX-DIM
CLX-4HSW4
CLX-1DELV4
CLX-1MC4
CLX-1FAN4
CLW-DIM
CLW-DIMS
CLW-SW
CLW-SWS
The Load Schedule toolbox provides two fixture libraries: Global and Project. Each
library contains 16 generic fixture categories.
When adding loads to your load schedule, you can select one of the 16 generic
fixtures from either library, or you can create your own user-defined fixtures that
appear as sub-categories of the generic categories. If you add a user-defined fixture to
the Global Library, that fixture will be available to any D3 Pro project you design on
your computer. If you add a user-defined fixture to the Project Library, that fixture is
available only in the current project.
Load Support
Incandescent (Dim, Non-Dim)
Magnetic Low Voltage (Dim, Non-Dim)
Electronic Low Voltage (Dim, Non-Dim)
Neon/Cold-Cathode (Dim, Non-Dim)
Fluorescent Dim (2-Wire) (Dim, Non-Dim)
Fluorescent Non-Dim
Switched
Switched
Incandescent (Non-Dim only)
Magnetic Low Voltage (Non-Dim only)
Electronic Low Voltage (Non-Dim only)
Neon/Cold-Cathode (Non-Dim only)
Fluorescent Dim (2-Wire) (Non-Dim only)
Fluorescent Non-Dim
H.I.D
Electronic Low Voltage (Dim, Non-Dim)
Incandescent (Dim, Non-Dim)
3-wire Motor
Ceiling Fan
Incandescent (Dim only)
Magnetic Low Voltage (Dim only)
Switched, i.e., general purpose fan (consult CLW-SW/S
documentation to verify the appropriateness of a particular
switched load)
Incandescent (Non-Dim only)
Magnetic Low Voltage (Non-Dim only)
Electronic Low Voltage (Non-Dim only)
Neon/Cold-Cathode (Non-Dim only)
Fluorescent. Dim (2-Wire) (Non-Dim only)
Fluorescent Non-Dim
H.I.D
Software
Crestron D3 Pro™• 21