Hyundai H-1 2005 Owner's Manual page 85

!
CAUTION:
If four wheel drive is to be used,
both the left and right free wheel
hubs must be set to the "LOCK"
position. Do not attempt to drive
the vehicle with the transfer shift
switch is selected to either the "4H"
or "4L" position if the free wheel
hubs are in the "FREE" position. If
the setting of the free wheel hubs is
to be changed after extended use of
the brake (such as for descending a
long slope), allow them to cool first.
The free wheel hubs can be become
extremely hot and could cause se-
vere burns.
D090C01P-GAT
Auto vacuum type free wheel
hubs (If installed)
The auto vacuum type free wheel hub
is designed to allow for automatic 4WD
engagement when the transfer shift
switch is selected to the 4H or 4L
position.
When engaging and disengaging, the
auto vacuum type free wheel hubs will
make a clicking noise. This is normal.
STARTING AND OPERATING
D090D02P-GAT
Transfer shift switch operation
By selecting the transfer shift
switch(4H, 4L), the both axles of the
vehicle are rigidly connected with each
other. This improves the traction char-
acteristics.
2H 4H
→
Select the 4H mode switch at speed
below 60~70 km/h. It is not necessary
to depress the clutch pedal (manual
transmission) or put the shift lever into
"N" position (automatic transmission).
Perform this operation when driving
straight.
4H 2H
→
Select the 2H mode switch. This can
be done at any speed, and it is not
necessary to depress the clutch pedal
(manual transmission) or put the shift
lever into "N" position (automatic trans-
mission). Perform this operation when
driving straight.
3
17