Hyundai H-1 2005 Owner's Manual page 57

B210A01A-AAT
To Release the Seat Belt
B210A01L
The seat belt is released by pressing
the release button in the locking buckle.
When it is released, the belt should
automatically draw back into the re-
tractor. If this does not happen, check
the belt to be sure it is not twisted, then
try again.
B370D01P-GAT
2-Point System with Non-Lock-
ing Retractor (If installed)
HFC2085
This type of seat belts are equipped
with an Non-Locking Retractor.
Holding the latch plate by hand, pull it
out until the webbing is fully extended
and insert the latch plate into the buckle.
When it fits snugly around your hip, the
webbing with the latch plate is auto-
matically retracted. To release, unfas-
ten the belt, and a light tug to the
webbing with the latch plate will cause
the retractor to work automatically.
BEFORE DRIVING YOUR VEHICLE
B370E01P-GAT
2-point Static Type (If installed)
Loosen
Tighten
GS10530A
The seat belts should be adjusted by
holding the belt and latch plate at right
angles to each other, and then pulling
the belt as illustrated below to a snug
fit around the occupant.
Holding the latch plate by hand, insert
the latch plate into the buckle.
1
43