Hyundai H-1 2005 Owner's Manual page 112

D060G01A-AAT
6. Changing Wheels
HSRFL061
Use the wrench to loosen the wheel
nuts, then remove them with your fin-
gers. Remove the wheel cover (if in-
stalled) from the wheel and slide the
wheel off the studs and lay it flat so it
cannot roll away. To put the wheel on
the hub, pick up the spare tire, line up
the holes with the studs and slide the
wheel onto them. If this is difficult, tip
the wheel slightly and get the top hole
in the wheel lined up with the top stud.
Then jiggle the wheel back and forth
until the wheel can be slid over the
other studs.
CORROSION PREVENTION AND APPEARANCE CARE
HSRFL062
!
WARNING:
Wheel covers may have sharp
edges. Handle them carefully to
avoid possible severe injury.
Before putting the wheel into place,
be sure that there is nothing on the
hub or wheel (such as mud, tar,
gravel, etc.) that interferes with the
wheel from fitting solidly against
the hub. If there is, remove it. If
there is not good contact on the
mounting surface between the
wheel and hub, the wheel nuts could
come loose and cause the loss of a
wheel. Loss of a wheel may result in
loss of control of the vehicle. This
may cause serious injury or death.
IN CASE OF EMERGENCY
D060H01A-AAT
7. Reinstall Wheel Nuts
HSRFL063
To reinstall the wheel cover, hold it on
the wheel and put the wheel nuts on
the studs and tighten them finger tight.
The nuts should be installed with their
small diameter ends directed inward.
Jiggle the tire to be sure it is completely
seated, then tighten the nuts with your
fingers again.
4 4
11 11